THE FOLLOWING SAFETY INFORMATION RELATING TO PUMP OPERATION AND MAINTENANCE SHOULD BE CAREFULLY OBSERVED, AND CORRECT PROCEDURES FOLLOWED, TO AVOID INJURIES TO PERSONNEL, AND DAMAGE TO EQUIPMENT. ALL STATUTORY REQUIREMENTS RELATING TO THIS EQUIPMENT MUST BE COMPLIED WITH AT ALL TIMES. DO NOT APPLY HEAT TO THE IMPELLER HUB OR INLET EYE TO ASSIST ...
1. The material must be able to bear slurry abrasion, erosion and corrosion. 2. In order to get a longer service life, under the same parameters paremeters, the working speed of horizontal slurry pump will be slower than clean water pump. 3. The bearing and roller of horizontal slurry pump can adapt to overloading, bad working condi ...
I. No liquid delivered by pump Possible causes 1. There is an air leak in the suction pipeline or the stuffing box. 2. The impeller rotates in a reverse motion or there is damage to the impeller. 3. The suction pipeline is clogged. Solutions1. Repair the leaky part. 2. Check the rotational direction or replace the damaged impeller. 3. Clear the clo ...
Model ZGB slurry pump is a cantilever-type horizontal single-stage- single-suction centrif- ugal pump, which is used in conveying various fine slurries (except slurry of cotton and flax clout) with aconcentration less than 6% and temperature less than 80t; Clean water performance of the pump is as follows: flow 32-150 m³/ h, lift9-37m. According to ...
Slurry pumps design affecting life and business a lot. Science will affect your choice of mud pump for maximum efficiency. Effective functioning of mud pump with three characteristics: Mud pump with high operational efficiency, reducing wear. Pump flow components are relatively longer life, lower production cost. Stability of the whole mining sys ...
1. Motor over current Causes (1)The head of pump is higher than the actual head of pipe. (2) Friction between the impeller and the backplate. (3) Low efficiency of motor (4) Bearing broke down (5) Non-concentricity of shaft and motor & ...
